Recent content by AlexMali

System Log confirmes that the trigger fires the change action. No other change action is fired after that. But still the same - notification volume is not changed. I even configured a loop firing the command as long as the volume is above the desired value. But even this does not work. It looks...

Tried this over the last days, but no change. Sometimes it works, but sometimes not.

Still the same. :-( Today when i entered the location "work", my macro was fired and performed the action to change ringer and announcements volume to 20% but only ringer volume was changed. There was no loss of coverage and no other macro fired the same time.

Tank you very much for this setup. This reduced the amount of my macros by half. For the moment it looks much more reliable, even if i still had one unexpected result over the last days. But for the moment i will keep it like this. Again - thanks for your help!

I tried a reinstall and tested it again today, but no change. I got some macros that are changing the volumes. One when i enter the location and one when I am leaving. Sometimes they are firing within a short time when I lose coverage. Is there a better way to configure this?

Ok i will give it a try. Does your Macro change two volume settings the same time? Like ringtone and notifications?

Done. Looking forward to your reply.

No that doesn't make a change. I just tried it today.

I have configured a macro to change ringtone an Notification volume while at work triggered by network cell location, but it changes just the ringtone volume and not the Notification volume. When i test the action manually it works fine but when it runns automated not. I am using a Samsung A71...